Other
On-Campus
Accredited by the Association of Technology, Management, and Applied Engineering (ATMAE)
The Engineering Design Technology program prepares individuals for employment as industrial design drafters and engineering technicians in specific disciplines. The curriculum incorporates guidelines developed by the American National Standards Institute, American Institute of Steel Construction, American Society of Mechanical Engineers, and ISO (International Standards Organization). Students may specialize in the following areas: Architectural/Construction, Piping, Structural, and Machine Design.
General Education Requirements
Note: All courses must be from the Approved Courses for General Education courses for each category listed in the General Education section of this catalog.
Learning Support
Additional courses may be required to overcome deficiencies in English, mathematics, and reading.
Fall
- EDUC 1030 - ♦College and Lifelong Learning Credits: 3
- ENGL 1010 - ♦English Composition I Credits: 3
- ENGR 1110 - ♦Engineering Graphics Credits: 3
- INTC 1010 - Quality and Inspection Credits: 3
- MATH 1050 - Trigonometric Applications Credits: 4
Spring
- Elective - Humanities Elective (an approved elective from the general education core) Credits: 3
- DRAF 1210 - Computer-Aided Drafting I Credits: 4
- ENST 1350 - Industrial Safety Credits: 3
- PHYS 1030 - ♦Survey of Physics Credits: 4
-
or
- PSCI 1010 - ♦Principles of Physical Science Credits: 4
- COMM 2025 - ♦Fundamentals of Communication Credits: 3
-
or
- COMM 2045 - ♦Public Speaking Credits: 3
Fall
- DRAF 1220 - Computer-Aided Drafting II Credits: 3
- INTC 1030 - Industrial Concepts Credits: 3
- Electives - Engineering Design Technology Electives (choose from the list below) Credits: 8
- Electives - Behavioral/Social Science Elective (an approved elective from the general education core) Credits: 3
Spring
- DRAF 1230 - Advanced Computer Aided Design Credits: 3
- DRAF 1310 - Construction Estimating/Project Management Credits: 3
- DRAF 2510 - Geometrical Dimensioning and Tolerancing Credits: 3
- Electives - Engineering Design Technology Electives (choose from the list below) Credits: 4
Engineering Design Technology Electives
- DRAF 2110 - Architectural/Construction Drafting and Design Credits: 4
- DRAF 2210 - Pipe Drafting and Design Credits: 4
- DRAF 2310 - Structural Detailing and Design Credits: 4
- DRAF 2710 - Machine Design Credits: 4
2425 Highway 75
Tennessee 37617 Blountville , United States
